RoboDK Forum> RoboDK (EN)> General questions about RoboDK> Mill with an external axis
RoboDK Forum> RoboDK (EN)> General questions about RoboDK> Mill with an external axis

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Mill with an external axis
serg_kub Offline
Member
**
Posts: 27
Threads: 7
Joined: Feb 2021
Reputation: 2
#9
06-02-2021, 05:04 AM
Yes, I know this. I checked everything again.
When I am in T1 mode, everything work well, when the table rotates, the cutter moves behind it.
But when I run the program in AUTO or EXTERNAL, it seems that the table with the robot is working separately.
Find
Reply


Messages In This Thread
Mill with an external axis - byserg_kub- 06-01-2021, 07:07 AM
RE: Mill with an external axis - byJeremy- 06-01-2021, 11:48 AM
RE: Mill with an external axis - byserg_kub- 06-01-2021, 12:30 PM
RE: Mill with an external axis - byJeremy- 06-01-2021, 01:26 PM
RE: Mill with an external axis - byserg_kub- 06-01-2021, 01:31 PM
RE: Mill with an external axis - byJeremy- 06-01-2021, 04:00 PM
RE: Mill with an external axis - byserg_kub- 06-01-2021, 04:16 PM
RE: Mill with an external axis - byAlbert- 06-01-2021, 06:14 PM
RE: Mill with an external axis - byserg_kub- 06-02-2021, 05:04 AM



Users browsing this thread:
1 Guest(s)