03-17-2020, 05:23 AM
嗨,艾伯特
followed the process of "calibrating the root point" described in the book "KUKA System Software 8.2" to test the operation of the base that is created in the process (on pages 113 and 114, attached screenshots)
take the measured root of the turntable from the same menu "External kinematic system" after the calibration, before it had the values of 0 in XYZABC, different from the trail
followed the process of "calibrating the root point" described in the book "KUKA System Software 8.2" to test the operation of the base that is created in the process (on pages 113 and 114, attached screenshots)
take the measured root of the turntable from the same menu "External kinematic system" after the calibration, before it had the values of 0 in XYZABC, different from the trail