03-10-2020, 04:44 PM
Hi hweilguni,
This is most likely because your config file was not edited properly.
The X means the program can't run, it's usually because the program is looking for a variable that was not declared in the config file.
Can you make sure it's edited correctly and that it's placed in the right folder of your robot controller?
Jeremy
This is most likely because your config file was not edited properly.
The X means the program can't run, it's usually because the program is looking for a variable that was not declared in the config file.
Can you make sure it's edited correctly and that it's placed in the right folder of your robot controller?
Jeremy