Curves Tool Orientation——革命制度党ntable Version +- RoboDK Forum (//www.sinclairbody.com/forum) +-- Forum: RoboDK (EN) (//www.sinclairbody.com/forum/Forum-RoboDK-EN) + - - -论坛:通用RoboDK问题(//www.sinclairbody.com/forum/Forum-General-questions-about-RoboDK) +--- Thread: Curves Tool Orientation (/Thread-Curves-Tool-Orientation)

Curves Tool Orientation-mmccrea_BAT-10-06-2020 When I import curves from Solidworks the tool is always 45degrees to the curve as shown below, I would like the tool to be 90 degrees to the curve, I would like the grey arrows to straight up. How do I change this? Thank you mark RE: Curves Tool Orientation-Olivier-10-06-2020 Hello mmccrea_BAT, Are you using the plugin for RoboDK in solidwork to import your curve? If yes, then when you select the curve, select a surface with it and the tool orientation will be normal to that surface in RoboDK. Olivier