+- RoboDK Forum (//www.sinclairbody.com/forum)
+-- Forum: RoboDK (EN) (//www.sinclairbody.com/forum/Forum-RoboDK-EN)
+--- Forum: RoboDK API (//www.sinclairbody.com/forum/Forum-RoboDK-API)
+--- Thread: Failed to connect to Jaka ZU 3 cobot (/Thread-Failed-to-connect-to-Jaka-ZU-3-cobot)
Pages:
1
2
RE: Failed to connect to Jaka ZU 3 cobot-IonutF-11-10-2020
Jeremy,
I am from Romania.
Ionut
RE: Failed to connect to Jaka ZU 3 cobot-mksingh-01-07-2021
hi jermy
当我尝试连接的robodk kuka kr3i am getting this messaage plesase help me out with this
Disconnected
Stopped
Starting robot driver: C:/RoboDK/api/robot/apikuka.exe
Starting...
Error: Process failed to start: The requested operation requires elevation. (id 0)
Cannot start C:/RoboDK/api/robot/apikuka.exe
Failed
DISCONNECT
Driver apikuka not running
Disconnected
Stopped
Starting robot driver: C:/RoboDK/api/robot/apikuka.exe
Starting...
Error: Process failed to start: The requested operation requires elevation. (id 0)
Cannot start C:/RoboDK/api/robot/apikuka.exe
Failed
Regards
Mukesh
RE: Failed to connect to Jaka ZU 3 cobot-Jeremy-01-07-2021
Hi Mukesh,
Did you follow these steps from our documentation?
//www.sinclairbody.com/doc/en/Robots-KUKA.html#KUKA
Jeremy
RE: Failed to connect to Jaka ZU 3 cobot-mksingh-01-19-2021
(01-07-2021, 03:38 PM)Jeremy Wrote:Hi Mukesh,
Did you follow these steps from our documentation?
//www.sinclairbody.com/doc/en/Robots-KUKA.html#KUKA
Jeremy
yes i followed these steps.
Hi Jermy,
i am able to connect my KUKA KR3 R540 but when i create a programme and tried to run it then there is no movement of my KUKA manipulator. the message shows its working . i doble click on the programme the yellow arrow stops on my first joint movement.
Regards
Mukesh